6 OPERATION
8
EPSON
S5U1C88000H5
(S1C88 FAMILY IN-CIRCUIT EMULATOR)
CHAPTER
6 O
PERATION
6.1 Starting up S5U1C88000H5 for Windows 98
The following shows the start-up procedure of the S5U1C88000H5 system.
(1) Turn the S5U1C88000H5 in-circuit emulator on.
Note: • After connecting the S5U1C88000H5 system, make sure that the equipment is installed and
connected correctly before turning the power on.
• After the S5U1C88000H5 is turned off, do not turn the S5U1C88000H5 on for at least 10
seconds. It may cause a malfunction in the S5U1C88000H5.
The S5U1C88000H5 debugger checks the S5U1C88000H5 hardware and files required. The check result is
displayed in the [Command] window. If any error message appears and the debugger does not start up
normally, terminate the debugger (choose [Exit] command from the [File] menu), then check the follow-
ing points.
- Is the Peripheral Circuit Board installed in the S5U1C88000H5 properly?
- Is the S5U1C88000H5 connected to the personal computer with the USB interface cable properly?
- Is the S5U1C88000H5 turned on?
- Is the appropriate parameter file prepared? (see Section 6.3)
(2) To start up the debugger, select Ice88ur.exe from the
program menu.
The debugger window below is appeared.
