Epson S5U1C17001C, Manual

Page: 613 / 742

10-162
EPSOn
S5U1C17001C ManUal
(C COMPilEr PaCkagE fOr S1C17 faMily) (Ver. 1.5.0)
10 DEBUggEr
10.10 Status and Error Messages
10.10.1 Status Messages
When the target program breaks, one of the following messages is displayed, indicating the cause of the break
immediately before entering the command input wait state.
Table 10.10.1.1 Status messages
Message Description
Breakpoint #, function at file : line Made to break at a set breakpoint
Break by accessing no map. Made to break by accessing unmapped area in simulator mode
Break by writing ROM area. Made to break by accessing read-only area in simulator mode
Break by stack overflow. Made to break by stack overflow in simulator mode
Illegal instruction. Made to break by executing invalid instruction in simulator mode
Illegal delayed instruction. Made to break by executing invalid delayed instruction in
simulator mode
Break by key break. Forcibly made to break by [Stop] button (in simulator mode)
Break by key break. Program received signal
SIGINT, Interrupt. Forcibly made to break by [Stop] button (in ICD Mini mode)
10.10.2 Error Messages
Table 10.10.2.1 Error messages (in alphabetical order)
Message Description
· · · gdb : unrecognized option ' option ' An illegal startup option is specified.
A setup of a serial port was not completed. An ICD mode not supported in gdb is specified.
Address is 24bit over. The specified address is out of the 24-bit range. The maximum
S1C17 address size is 24 bits (0xffffff).
Address(0x # ) is ext or delayed instruction. The specified address cannot be set due to an ext or delayed
instruction.
C17 command error, command is not supported at
present mode. The input command cannot be executed in the current connect
mode (ICD Mini or simulator mode).
C17 command error, command is too long. The input command exceeds 256 characters in length.
C17 command error, invalid command. The command is erroneous.
C17 command error, invalid parameter. The command is specified with an invalid parameter.
C17 command error, number of parameter. The number of command parameters is incorrect.
C17 command error, start address > end address. The specified start address is greater than the end address.
C17 command error, start cycle < end cycle. The specified start cycle is greater than the end cycle.
Cannot access memory. The specified address cannot be accessed.
Cannot allocate memory. The necessary size of memory area as specified by a parameter
could not be reserved.
Cannot clear hard pc break(0x # ). The specified hardware PC break address is invalid; no
breakpoints are set there.
Cannot clear soft pc break(0x # ). The specified software PC break address is invalid; no
breakpoints are set there.
Cannot display clock counter.
Now Timer break mode is on.
Please timer break mode off. The execution counter value cannot be displayed when the
lapse of time break is enabled. Disable the lapse of time break
before execution times can be measured.
Cannot display clock counter.
Time measurement should use continue or until
command. The execution counter value cannot be displayed if the con-
tinue or until command has not been executed.
Cannot measure clock timer. The program execution time cannot be measured as it is too
short.
Cannot open file(
file
). Cannot open the file.
Cannot open ICD17 usb driver. Failed to open the USB drive.
Cannot set hard pc break any more. The number of hardware PC breakpoints set exceeds the limit
(one location only).
Cannot set soft pc break any more. The number of software PC breakpoints set exceeds the limit (up
to 200).