Introduction
S5U13C00P01C100 Board User Manual
Seiko Epson Corporation
3
(Rev. 1.0)
1.
Introduction
The S5U13C00P01C100 is the
S1D13C00 EPD Evaluation Board
. It is a BoosterPack board with a connector
for the E Ink ET011TT2 EPD panel intended to be directly connected to the TI Tiva C Series EK-TM4C1294XL
Launchpad evaluation board for evaluating and developing embedded EPD applications using the Epson
S1D13C00 Memory Display Controller IC. It is possible to be controlled by the ST Nucleo-F746ZG or Nucleo-
F767ZI board through the S5U13C00M00C100 (STM32 Nucleo-144 development board) board.
Figure 1 shows the S5U13C00P01C100 EPD Evaluation Board.
Figure 1 – S5U13C00P01C100 EPD Evaluation Board
The S5U13C00P01C100 EPD Evaluation Board consists of:
A S1D13C00 Memory Display Controller (U1)
Four 2x10 connectors for Host Interface connection (J4, J5, J6 and J7) and +5V/+3.3V power
A 16Mbytes QSPI Serial Flash (U2)
A flexible printed circuit (FPC) connector (CN2) for connecting to a ET011TT2 EPD panel
An 18-pin right-angle header connector for connecting to other panels
Figure 1.1 shows the block diagram of S5U13C00P01C100, focused on interfaces. It has a host MCU interface
and three interfaces for displays. CN1 is an interface for E Ink’s HULK power board, CN2 is an interface for the
ET011TT2 panel module, and there are through holes for interface to a memory display panel. You can select
one of these interfaces to connect a panel module. CN2 interface is also possible to connect other E Ink panel
modules. The booster components on the S5U13C00P01C100 are similar circuits to HULK power board
suitable for the ET011TT2 panel module.
