CHAPTER 2: INSTALLING S5U1C63004P
2
EPSON
S5U1C63004P MANUAL (PERIPHERAL CIRCUIT
BOARD FOR S1C63454/63455/63458/63466)
CHAPTER
2 I
NSTALLING
S5U1C63004P
2.1 Installing the S5U1C63004P in the ICE (S5U1C63000H1)
(1) Unfasten the screws located on the left and right sides of the front panel of the ICE by turning them
counterclockwise, then remove the front panel.
(2) Insert the S5U1C63004P board into the ICE along the its uppermost guide rails until the tip of the board
touches the back of the ICE. If some other board is mounted on the uppermost guide rails, remove that
board by using the jig supplied with the ICE before you insert the S5U1C63004P board (see Figure 2.1.3).
(3) Once the S5U1C63004P board has been inserted almost fully into the ICE, secure it in position by
using the jig supplied with the ICE (see Figure 2.1.2).
(4) When the above is done, replace the front panel.
(1), (4)
(2)
(3)
S5U1C63004P Board
Fig. 2.1.1 Installing the S5U1C63004P board in the ICE
•
Installing the S5U1C63004P board
Set the jig included with the ICE into position as
shown below. Using this jig as a lever, push it
toward the inside of the board evenly on the left
and right sides. After confirming that the
S5U1C63004P board has been firmly fitted into
the internal slot of the ICE, remove the jig.
•
Dismounting the S5U1C63004P board
Set the jig included with the ICE into position as
shown below. Using this jig as a lever, push it
toward the outside of the board evenly on the
left and right sides. After confirming that the
S5U1C63004P board has been dismounted from
the backboard connector, pull the S5U1C63004P
board out of the ICE.
S5U1C63004P Board
S5U1C63004P Board
Fig. 2.1.2
Installing the S5U1C63004P board
Fig. 2.1.3
Dismounting the S5U1C63004P board
