Epson RX595 - Stylus Photo Color Inkjet, Service Manual, Page: 77 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Disassembly and Assembly Disassembly of Scanner Unit 77
4.3 Disassembly of Scanner Unit
4.3.1 Scanner Housing
1. Remove the Scanner Unit (p.65)
2. Remove the screws (x6) on the bottom of the Scanner Unit. (Fig. 4-39)
3. Remove the Scanner Housing, the hinge area in the rear of the Scanner Unit first.
Figure 4-39. Removing the Scanner Housing
Figure 4-40. Lubrication Point on CR Guide
C A U T I O N
„ Once the Scanner Housing is removed, there is a possibility that
dust and dirt may enter the inside of the scanner body. Perform
disassembly and assembly of the Scanner Unit in an
environment that minimizes intrusion of dust and dirt.
Disassembly and assembly on a clean bench is ideal.
„ Perform disassembly and assembly with care not to damage the
document table (glass). In addition, never forget that a very
troublesome cleaning is required if dirt sticks to the inside of
the document table.
„ Take care in handling the Housing Lower, remembering that
grease is applied to the CR guide area of the Housing Lower.
Do not touch any parts with a greasy hand or part.
(Fig. 4-40)
„ Take care not to soil or scratch the Encoder Scale or the lens of
the ICS Unit.
„ When installing the Scanner Housing, engage the hooks (x3) in
the front properly first and then engage the hinge area in the
rear.
„ Tighten the screws in the specified order. (Fig. 4-39)
A D J U S T M E N T
R E Q U I R E D
When, in subsequent work, the Carriage Assy is removed, or for
some other reason, the scanner origin can be shifted from the
correct position. After reinstallation, therefore, adjust the origin
location.
Refer to
“5.4 Scanner Original Adjustment” (p.112)
C.B.P-TITE 2.5x10 (x6)
Torque : 0.5±0.1N
·
m
Remove the hinge side first
Hook (x3)
Lubrication Point
Do not soil or
scratch the lens
Do not soil or
scratch the scale