Epson R220 - Stylus Photo Color Inkjet Printer, Service Manual

Page: 51 / 117

EPSON Stylus Photo R220/R230 Revision A
DISASSEMBLY / ASSEMBLY Disassembly 51
†
When reassembling the ASF Assy.
„
Make sure that Extension Spring is hooked on the Frame,
ASF and the Roller, Retard Assy.
„
Make sure that Torsion Spring, 6.45 is correctly installed on
the Paper Return Lever and the Frame, ASF.
Figure 2-8. Torsion Springs, 6.45 installation
„
Make sure that the Paper Return Lever and the Roller,
Retard Assy. move smoothly.
„
Do not touch the cork on the Roller, Retard Assy. and the
Hopper.
„
First secure the Support Plate, Frame, ASF, Right with a
screw and then secure the Support Plate, Frame, ASF, Left
with a screw.
Figure 2-9. Support Plate, Frame, ASF installation
Torsion Spring, 6.45
1
2
†
When reinstalling the ASF Assy. on the Frame, Main
„
Make sure that Compression Spring, 2.51 is correctly
installed on the Hopper.
Figure 2-10. Torsion Springs, 2.51 installation
„
Make sure that the Hopper moves smoothly.
„
Make sure that there is no clearance between the ASF Assy.
and the Frame, Main.
„
Secure the ASF Assy. with five screws following the order of
Figure2-7 .
†
PG Sensor/Sensor, CDR Assy. Connector Cables reinstallation
„
Secure the Connector Cables of the PG Sensor and Sensor,
CDR Assy. to the ASF Assy. with two screws following the
order shown in
Figure2-7 .
A D J U S T M E N T
R E Q U I R E D
†
When having replaced ASF Assy., apply G-46 grease to the
specified points in adequate dose.
(Refer to Chapter 4 “MAINTENANCE”)
†
When having replaced or removed ASF Assy., perform the
following adjustment.
(Refer to Chapter 3 “ADJUSTMENT”)
1. First dot Adjustment
Compression Spring, 2.51