Epson PowerLite EB-800F, User Manual, Page: 264 / 303

264
Solutions When an Afterimage Remains On the Projected Image
If you see an afterimage in the projected image, select Refresh Mode > Start in the Management
menu.
Parent topic: Solving Image or Sound Problems
Related references
Administration Settings - Management Menu
Solutions to Sound Problems
If there is no sound when you expect it or the volume is too low or high, try the following solutions:
• Adjust the projector's volume settings.
• Press the A/V Mute button on the remote control to resume video and audio if they were temporarily
stopped.
• Check your computer or video source to make sure the volume is turned up and the audio output is set
for the correct source.
• Try disconnecting and reconnecting the audio cable.
• Check the audio cable connections between the projector and your video source.
• If you do not hear sound from an HDMI source, set the connected device to PCM output.
• Make sure any connected audio cables are labeled "No Resistance."
• If you are using a Mac and you do not hear sound from an HDMI source, make sure your Mac
supports audio through the HDMI port. If not, you need to connect an audio cable.
• If you want to use a connected audio source when the projector isn't projecting any images, set the
Quick Startup option in the Operation menu to Off and make sure the A/V Output setting in the
Signal I/O menu is set to Always On .
• If the volume for the computer is set to the minimum while the projector's volume is set to maximum,
the sound level may be mixed. Turn up the computer's volume and decrease the projector's volume
(when using Epson iProjection [Windows/Mac]).
• Make sure the Audio Output Device option is set to the correct audio port for your video device.
• If you turn the projector on immediately after turning it off, the cooling fans may run at high speed
momentarily and cause an unexpected noise. This is normal.
Parent topic: Solving Image or Sound Problems
Related references
Input Signal Settings - Signal I/O Menu