Epson MX-80 F/T Type II, Operation Manual

Page: 64 / 103

NOTES: 1. The Top of Form is determined when the POWER switch is turned on or
the INIT signal is applied.
2. If the form length per page is not set, one page length of form is regarded as
66 lines with the DIP switch pin 1-2 on the control circuit board set in the
OFF position or 72 lines with the DIP switch pin 1-2 set in the ON position.
(The amount of line spacing is governed by the DIP switch setting at that
time. When power is applied, the amount of line spacing is set at 1/6 inch
with the DIP switch 1-1 set in the OFF position or 1/8 inch with the DIP
switch pin 1-1 set in the ON position.)
3. The form length can be set by ESC C + n or ESC C + <0>
H
+ m as described
later.
3.2. Paper formatting codes
(1)
HT
(Horizontal Tabulation)
The HT code
carries out the horizontal tabulation to a predetermined position
set by
“ E S C
D” (up to
12
p o s i t i o n s ) .
T h e
t a b s e t t i n g e x c e e d i n g t h e c o l u m n
length set by the DIP switch or ESC code will be ignored. In enlarged character
mode, the tab setting will not be effective and will be ignored.
(2) ESC D + n
1
+ n
2
+ . . . . . + n
k
+ N U L
This code specifies the horizontal tab stop positions. “n” denotes column
position where the print head stops. The first 12 tab stops per line are
recognized in the Printer, and subsequent tab stops are ignored. The tab stop
positions can be specified up to
80
columns in normal character mode and
1 3 2
columns in condensed character mode. The excess tab positions, if specified,
will be ignored.
in normal character mode
in condensed character mode
In enlarged character mode, the tabulation is not effective. To execute tabula-
tion, the HT code should be input.
The NUL code should be input as the command for the termination of the
tab set sequence, and the lack of this code will cause incorrect data printout.
- 5 8 -
.-