Epson ML 3320, Owner'S Manual

Page: 17 / 23

English
11 Read Me First
➊
Switching Paper Paths
To switch from continuous-forms to single-sheet feed:
1. Tear off any printed pages.
2. Press PARK.
3. Move the paper separator to the single-sheet feed position.
4. Place the wire feed guide in the paper separator.
5. Move the paper lever to the position marked “TOP.”
6. Place a sheet of paper in the paper separator.
To switch from single-sheet feed to continuous forms:
1. Press FF/LOAD to remove the single-sheet paper.
2. Lower the paper separator into the continuous-forms
position and swing the wire feed guide over onto the
pull-up roller.
3. Move the paper lever to the position marked “REAR” or
“BOT,” as appropriate.
4. Load continuous-form paper, then press FF/LOAD.
Setting the Printhead Gap
The printhead gap is the distance between the printhead and
the platen. To adjust the gap, open the access cover and move
the blue lever (
➊
) to the recommended setting from the table
below.
Note: It is recommended that the printer be switched off
prior to removing the access cover.
Media Setting Media Setting
45-75g/m² paper 1 2-part form (w/carbon) 3-4
75-90g/m² bond paper 2 3-part form (w/carbon) 4-5
Labels 3-4 4-part form (w/carbon) 5
Envelopes 5
3320rmf3.pm6 13/03/96, 16:08 11