Start Here
12
Close the printer cover.
13
Press and hold the
ink button for
5 seconds until the
i
nk light starts to flash and ink charging begins.
Note:
Ink charging takes about 10 minutes. When the power
and
ink lights stop flashing, ink charging is complete.
Caution:
Do not turn off the product, open the printer cover, or
load paper while the product is charging or you’ll waste ink.
14
After the initial ink charging is complete, repeat steps 3 to
13 using the remaining ink in the ink bottle to refill the ink
tank.
3
Load paper
See the online User’s Guide for information about loading
capacity and available paper types and sizes.
1
Make sure the product is done charging the ink, then
open the front cover and pull out the paper cassette until
it stops.
IMPORTANT: Before using this product, make sure you read these
instructions and the safety instructions in the online User’s Guide.
Note:
The illustrations show the M1120, but the steps are the same for
both models, unless otherwise specified.
1
Unpack
Note:
Do not open either of the ink bottles until you are ready to fill the
ink tank. The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
Caution:
Do not touch the flat, white cable or the translucent
film inside the printer.
2
Close the printer cover.
Note:
Do not turn on the product yet.
2
Fill ink tank and charge
the ink
Warning:
Keep the ink bottles out of the reach of children and do not
drink the ink.
Caution:
This product requires careful handling of ink. If ink spills,
wipe it off immediately with a damp towel to avoid permanent stains. If
ink gets on your clothes or belongings, it may not come off.
Note:
• Epson cannot guarantee the quality or reliability of non-genuine ink.
• Use one of the ink bottles included with the printer to set up the
product. Part of the ink will be used to charge the print head. This
bottle may print fewer pages compared with subsequent ink bottles.
1
Connect the power cord to the back of the product and
to an electrical outlet.
Caution:
Do not connect to your computer yet.
2
Press the power button to turn on the product, then
wait for the power light to stop flashing.
3
Open the printer cover.
4
Press and hold the ink button for
5 seconds until the
ink and power lights start to flash.
5
When the ink light stops flashing, make sure the ink
tank is in the ink filling position and aligned with the
mark.
6
Open the ink tank cap.
7
Unpack one of the ink bottles. Hold the ink bottle upright
and slowly turn the bottle cap to remove it.
Caution:
Do not shake or squeeze the ink bottle. Do not touch
the top of the ink bottle after its cap is removed.
8
Insert the ink bottle into the filling port, as shown below.
Note:
Do not force the bottle into position.
9
Wait for the ink to fill the tank.
Do not squeeze the bottle.
Note:
Ink flows into the tank and stops automatically when the
ink tank is filled to the upper line. If ink does not flow from the
bottle, lift and reinsert the bottle.
10
When the ink tank is full, remove the ink bottle and
securely close it with the bottle cap.
Note:
Do not leave the ink bottle inserted; otherwise the bottle
may be damaged or ink may leak. If any ink remains in the bottle,
store the bottle upright for later use.
11
Close the ink tank cap.
M1100/M1120
4136508 Rev.0
1-F
C
4136508 Rev.0
1-F
M
4136508 Rev.0
1-F
Y
4136508 Rev.0
1-F
K
