2-30
Using the Printer
R4C4610
Rev. C
A5 size
USING.FM
6/28/00
Pass 3
L
Proof Sign-off:
SEI
Y.Ohkawara K.Kono
K.Kono
SEI
M.Kauppi
Auto CR (carriage return)
This setting is available only in IBM 2380 Plus emulation mode.
When auto carriage return is on, each line feed (LF) code or ESC
J code is accompanied by a carriage return code. This moves the
print position to the beginning of the next line. If the printer adds
an extra line after every carriage return, select
Off
.
IBM character table
This setting is available only in IBM 2380 Plus emulation mode.
When you select
Table 1
, hex codes 00H to 1FH and 80H to 9FH
of the character tables are used for the control codes. When you
select
Table 2
, hex codes 00H to 1FX are used for control codes
and 80H to 9FH are used for characters.
Changing default settings
Follow the steps on the next page to enter the default-setting mode
and change the printer’s default settings.
Note:
❏
To print the language selection and default-setting mode
instructions, you need five sheets of A4 or letter size single-sheet
paper, or five pages of continuous paper that is at least 279 mm (11
inches) long and 210 mm (8.27 inches) wide. See the instructions
in this chapter for loading continuous paper or single sheets.
❏
If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
