REV.-B
3.2.5.2 Removing the MOTOR, PF
1. Remove the PRINTER MECHANISM from the HOUSING
LOWER(see Section 3.2.4).
2. Remove the COMPRESSION SPRING, 200 that holds the platen shaft.
3. Release the two clips holding the MOTOR,
to
the FRAME, MAIN, RIGHT.
4. Remove the MOTOR,
from the FRAME, MAIN, RIGHT.
FRAME, MAIN, RIGHT
PF
Figure 3-12. Removing the MOTOR,
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the motor cable.
3.2.5.3 Removing the
(CABLE, HEAD,
2.
3.
4.
5.
Remove the printhead (see Section 3.2. 1).
Remove the PRINTER MECHANISM from the HOUSING
LOWER (see Section 3.2.4).
Remove the
from the clips that hold it along the rear side of the PRINTER MECHANISM. Make
sure that the
is free.
Remove the
from clip on the HOLDING PLATE,
at the rear of the PRINTER MECHANISM.
Remove the four clips that hold the HOLDING PLATE,
to the base frame. Remove the
together
with the HOLDING PLATE,
.
.
CABLE, HEAD, FRONT
CABLE, HEAD, REAR
I
Figure 3-13. Removing the
Cable
Point to Note for Assembly
See Section 3.2.5.13 for details on arranging and positioning the
3-11
Summary of Contents for LQ-1070+
