Epson HDBaseT ELPHD01, User Manual

Page: 18 / 100

18
Supported LAN Cables
Use a category 5e or category 6 straight STP cable. When using a cable,
use a tester to check that the cable's properties are at least category 5e
before connecting. When using a relay connector, make sure the connecting
cables meet the specifications mentioned above.
f Power inlet Connects the AC adapter's power plug.
Do not use a different power supply (AC adapter/
power cable). Only use the one supplied.
Note that when the power cable is plugged in, this
device turns on automatically (Direct Power On)
when power is restored after a power outage.
g [Sleep Mode]
switch When set to [Enable], the device automatically
enters sleep mode and turns off after 30 minutes
if no signals are input. Press the power button to
turn the device back on.
When set to [Disable], the device does not turn
off automatically. When monitoring and
controlling using HDBaseT, set this to [Disable]
so that the device does not enter sleep mode.
If the device is connected to an access point over
a LAN connection, it will not turn off even when
sleep mode is enabled.
h Wired-IR In port Connects the projector's optional remote control
cable set (ELPKC28) and inputs signals from the
remote control.
i
Link indicator Turns green when communicating with the
projector.
j
HDBaseT port Allows the device to connect to a projector using
a LAN cable.
k
FG connector
(earth) Grounds the earth wire.