Epson FX 890 - B/W Dot-matrix Printer, Service Manual

Page: 68 / 106

FX-1180/FX-880 Service Manual
Chapter 4 DISASSEMBLY AND ASSEMBLY
Rev. B
4-19
4.2.10.6 Front PE (Paper End) Detector Removal
1. Remove the printer mechanism. (See Section 4.2.9.)
2. Release 2 clips attaching the front PE detector to the REAR PAPER GUIDE ASSEMBLY, and
remove the detector.
3. Disconnect the harness from the detector.
R E A R P A P E R G U I D E A S S M E B L Y
F r o n t P E D e t e c t o r
C l i p
Figure 4-17. Front PE Detector Removal
4.2.10.7 Rear PE Detector Removal
1. Remove the printer mechanism. (See Section 4.2.9.)
2. Hold the printer mechanism horizontally.
3. Release 2 clips securing Rear PE detector to REAR PAPER GUIDE ASSEMBLY. (
①
)
4. Release 2 notches on the REAR PAPER GUIDE ASSEMBLY securing the detector, and slide
the detector toward rear a little. Then remove the detector by pulling it downward. (
②
)
5. Disconnect the harness from the detector.
R e a r P E D e t e c t o r
C l i p s
R E A R P A P E R G U I D E A S S E M B L Y
F R A M E , R E A R
Figure 4-18. Rear PE Detector Removal