29
13
Connect the
Video Cable
to the
OUTPUT
end of the HDMI repeater. Then connect the
INPUT
end of
the HDMI repeater to the other video cable that you already placed near the screen (see page 27).
14
Connect the power supply for the HDMI repeater to the power inlet on the repeater.
15
Secure the cables inside the screen under the molded plastic cable covers. Flex the covers upward to lift
them slightly, then slip the cables underneath. The cables going to the projector should exit from the break
in the covers near the middle. Let them hang over the front of the screen.
Tip
If you anticipate having a lot of excess cable near the projector, you may be able to tuck some of the cable under
the long cable cover shown below.
Lift the Screen onto the Mounting Brackets
Note
You may wish to attach the wire management tracks to your wall and ceiling first (see “Connecting and Routing the
Cables” on page 43). It is easier to attach the tracks near the screen before the screen has been mounted. Return to this
section later once the tracks are in place.
1
Before lifting the screen, make sure no loose cables hang out from the back of the screen. Make sure all the
cables inside the screen are secured under the cable covers so they won’t get pinched against the wall or
mounting brackets when you mount the screen.
To projector
To AV controller
input
output
Cables to
projector
Store excess cable under
the long cable cover
Summary of Contents for Ensemble HD
Page 1: ...Installation Guide ...
