ISSUED: 02-13-08 SHEET #: 054-9126-2 07-10-08
Visit the Peerless Web Site at www.peerlessmounts.com
2 of 7
For Technical Support Contact Peerless Mounts at 1-800-729-0307 or 708-865-8870.
Table of Contents
Parts List .............................................................................................................................................................................. 3
Extension Column and Flush Mounting Applications ............................................................................................................ 4
Installation to Wood Joist Finished Ceilings, Exposed Wood Joists or Wood Beam Ceilings ............................................... 5
Installation to Solid Concrete ................................................................................................................................................ 6
Warranty Information ............................................................................................................................................................. 7
NOTE:
Read entire instruction sheet before you start installation and assembly.
• Do not begin to install your product until you have read and understood the instructions and warnings contained in this
Installation Sheet. If you have any questions regarding any of the instructions or warnings, call Peerless customer care
at 1-800-729-0307.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity.
• If mounting to wood joists or wood beam ceilings, make sure that mounting screws are anchored into the center of the
joists or beams. Use of an "edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal
injury.
• When installing or adjusting the ceiling mount, do not use adhesives, lubricants, or oils to prevent the screws from
loosening. If you use adhesives, lubricants, or oils to prevent the screws from loosening, the casing may crack and the
projector may fall, causing serious injury and damage to the projector.
WARNING
Tools Needed for Assembly
•
stud finder ("edge to edge" stud finder is recommended)
•
phillips screwdriver
•
3/8" (10 mm) socket wrench
•
drill
•
1/4" bit for concrete surface
•
5/32" bit for wood studs
