Extended Menu
99
The projector for which you perform this feature becomes a master
projector, and the adjustment is performed based on the projector's image
position and shape.
a
• Connect two projectors using a LAN cable.
• Make sure you do the following before adjusting:
• Set the
DHCP
setting to
On
in the projector's
Network
menu for
two projectors.
s
Network
>
Network Configuration
>
Wired LAN
>
IP
Settings
• Adjust the image position, shape, and focus on the master
projector. If you adjust the image shape of the master projector,
select
Point Correction
and select
Quick Corner
to correct the
shape.
• The required time for simple stacking varies depending on the
projector layout. It takes up to approximately 4 minutes.
g
g
Related Links
• "Conditions for Simple Stacking"
Conditions for Simple Stacking
You can use the simple stacking feature under the following conditions:
• All of the projectors are the same model and the optional external camera is
installed on each projector.
• Wait for 2 minutes after turning on two projectors before starting the
simple stacking process.
• You are projecting on a matte white diffusion screen that is flat and even.
• The projector is placed so it squarely faces the screen, not at an angle.
• Nothing is blocking the optional external camera and the projected image.
• The projection size is within the following range according to the brightness
of the light source (when the screen illuminance is 40 lux or less).
• Up to 9.9 Klm: 50 to 200 inches
• 10 Klm: 60 to 300 inches
• All the projectors are projecting images at the same resolution.
• The illuminance ratio on the screen surface when projecting an all-white
screen and when projecting an all-black screen is 8:1 or more.
•
Projection
in the projector's
Extended
menu is set to
Front
or
Front/Ceiling
for all projectors.
Schedule Settings
s
Extended
>
Schedule Settings
s
Extended
>
Multi-Projection
>
Screen Matching
>
Schedule Settings
You can schedule various projector tasks.
Schedule Settings
Select
Add New
to schedule events. To save your events, select
Setup
complete
and then select
Yes
.
•
Event Settings
to select the event details you want to perform. Select
No
Change
for items that you do not want to change when the event occurs.
•
Date / Time Settings
to select the date and time at which you want the
event to occur. You can schedule events up to 4 weeks later.
Schedule Reset
You can delete all scheduled events. To delete events completely, you need
to select
Setup complete
and select
Yes
.
Setup complete
Saves your changes in the
Schedule Settings
menu.
a
• In the
Schedule
menu, you can schedule up to 30 events.
• In the
Extended Schedule
menu, you can schedule only one event
for
Color Calibration
or
Screen Matching
.
• Light Source Calibration events do not start if the projector is used
continuously for more than 24 hours, or regularly turned off by
turning off the power outlet. Set the following events:
• Turning on the projector 20 minutes before performing light
source calibration.
• Performing light source calibration periodically.
