Epson EB-L25000U, User Manual

Page: 193 / 231

Using the Mail Notification Function to Report
Problems
When you set Mail Notification, notification messages are sent to the preset
email addresses when a problem or warning occurs with a projector. This
will enable the operator to be notified of problems with projectors even at
locations away from the projectors.
s
Network - Notifications - Mail Notification p.134
a
•
Up to a maximum of three notification destinations (addresses) can
be registered, and notification messages can be sent to all three
destinations at once.
•
If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
•
If you set Standby Mode to Communication On , you can control
the projector even if it is in standby mode (when the power is
off).
s
Extended - Standby Mode p.125
Reading error notification mail
When the Mail Notification function is set to On and a problem or warning
occurs in the projector, the following email will be sent.
Sender: The email address set in From
Subject: EPSON Projector
Line 1: The projector name where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The main message
contents are listed below.
•
Clean Air Filter
•
Internal error
•
Fan related error
•
Sensor error
•
Laser error
•
Laser warning
•
Retardation Plate Error
•
Internal temperature error
•
High-speed cooling in progress
•
Low Air Flow
•
Low Air Flow Error
•
No-signal
No Signal is input to the projector. Check the connection status or check
that the power for the signal source is turned on.
•
Lens shift error
•
No lens
•
Peltier Device error
See the following to deal with problems or warnings.
s
"Reading the Indicators" p.148
Monitoring and Controlling
193