Others menu
Submenu
Function
SNMP
Set to
On
to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is
Off
.
Trap IP Address
1/Trap IP Ad‐
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
Priority Gateway
(EB-925/
EB-915W/
EB-905/EB-96W/
EB-95 only)
You can set the priority gateway to a
Wired LAN
or
Wireless
LAN
.
Submenu
Function
AMX Device Dis‐
covery
When the projector is connected to a network, set this to
On
when you want to enable the projector to be detected by AMX
Device Discovery
. Set this to
Off
if you are not connected to an
environment controlled by a controller from AMX or AMX
Device Discovery.
RoomView
Set this to
On
only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to
Off
.
s
When this is set to
On
, the following functions are not available.
•
Web control
•
Message Broadcasting (EasyMP Monitor Plug-in)
List of Functions
90
Summary of Contents for EB-900
