Epson EB-824H, User Manual, Page: 82 / 136

Status Cause Remedy or Status
Check that the lamp cover and lamp are securely installed.
s
p.96
If the lamp cover or the lamp are not installed correctly, the lamp does not turn on.
When using at an altitude of 1500 m or more, set High Altitude Mode to On .
s
p.63
Auto Iris Error
Power Err. (Ballast) Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide.
s
Epson Projector Contact List
m o
Indicators are flashing or lit orange
: Lit : Flashing : Off : Varies according to the projector status
Status Cause Remedy or Status
High Temp Warning (This is not an abnormality. However, if the temperature rises too high again, projection stops automatically.)
•
Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
•
If the air filter is clogged, clean or replace it.
s
p.94 , p.99
Replace Lamp Replace it with a new Lamp.
s
p.96
If you continue to use the Lamp after the replacement period has passed, the possibility that the lamp may explode increases. Replace it
with a new Lamp as soon as possible.
q
•
If the projector is not operating properly, even though the indicators are all showing normal, refer to "When the Indicators Provide No Help" p.83 .
•
If the error is not indicated in this table, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the
nearest address provided in the Support and Service Guide.
s
Epson Projector Contact List
Problem Solving
82