Make sure you configure the administrator password before setting IPsec/IP filtering or IEEE802.1X.
Controlling Using Protocols
You can scan using a variety of pathways and protocols. Also, you can use network scanning from an unspecified
number of network computers.
You can lower unintended security risks by restricting scanning from specific pathways or by controlling the
available functions.
Controlling protocols
Configure the protocol settings supported by the scanner.
1.
Access Web Config and then select the
Network Security
tab >
Protocol
.
2.
Configure each item.
3.
Click
Next
.
4.
Click
OK
.
The settings are applied to the scanner.
Related Information
&
“Running Web Config on a Web Browser” on page 25
Protocols you can Enable or Disable
Protocol
Description
Bonjour Settings
You can specify whether to use Bonjour. Bonjour is used to search for devices, scan, and so on.
SLP Settings
You can enable or disable the SLP function. SLP is used for push scanning and network
searching in EpsonNet Config.
WSD Settings
You can enable or disable the WSD function. When this is enabled, you can add WSD devices,
and scan from the WSD port.
LLTD Settings
You can enable or disable the LLTD function. When this is enabled, it is displayed on the
Windows network map.
LLMNR Settings
You can enable or disable the LLMNR function. When this is enabled, you can use name
resolution without NetBIOS even if you cannot use DNS.
SNMPv1/v2c Settings
You can specify whether or not to enable SNMPv1/v2c. This is used to set up devices,
monitoring, and so on.
SNMPv3 Settings
You can specify whether or not to enable SNMPv3. This is used to set up encrypted devices,
monitoring, etc.
>
>
135