14
Step 14 Installing the Central Tube Support Bracket & Aligning the Tubes
The Tube Support Bracket has Self Adhesive Strips on it. Use an alcohol or cleaning solution and clean the top of
the printer housing where the Tube Support Bracket is going to be attached, see Fig.36. Then make sure the area is
dry before proceeding.
Remove the adhesive backing off both ends. Carefully install and align the Tube Support Bracket in its proper
location 47mm from the right edge of the recess, as shown in Fig.36 or the 3
rd
square from the right as illustrated.
3
rd
2
nd
1
st
47mm
When you have aligned and fixed the Tube Support Bracket in its position as illustrated in Fig.37 below. Please
ensure that the Central Tube Support Bracket, the top and bottom are firmly stuck down to the printer body.
The
tubes can now be inserted through the available opening in the middle of the bracket by squeezing the
tubes as
indicated in Fig.38 below.
Fig.35
Fig.36
Fig.37
Fig.38
