If you select
BarCode
, the printer converts bit images to bar codes by automatically filling in any
vertical gaps between dots. This produces unbroken vertical lines that can be read by a bar code reader.
This mode will reduce the size of the image being printed, and may also cause some distortion when
printing bit image graphics.
ZeroChar
Selects whether the printer prints a slashed or unslashed zero.
CharacterSet
Selects character table 1 or 2.
Password Config Menu
Item
Settings (default in bold)
Password Config
*
-
Limitation
Disable
, Interface, Config, All
*
The default password is blank. You can enter up to 20 characters for the password.
Password Config
Changes the password. Enter the old password first and then enter the new password twice.
To enter the password, press the
d
Down
or
u
Up
button to select the character and press the
r
Right
button to determine the character. After all characters are determined, press the
OK
button.
Note:
If you forget your password, contact your dealer. Note that when the password is initialized, the settings
and data stored on the printer are deleted. Depending on your environment, settings, such as network
connection settings, may need to be done again. We recommend making a note or backup of the
necessary data and setting information.
Limitation
Epson AcuLaser C9300 Series User's Guide
Using the Control Panel
87
