4.
If you removed the only IDE device connected to the
interface the device used, you may want to disconnect the
device cable from the interface on the system board and
remove it from the computer.
5.
If you have finished installing or removing drives, replace
the computer’s cover; see “Replacing the Cover” in
Chapter 4 for instructions. Then see “Running SETUP” in
Chapter 2 for instructions on defining your new drive
configuration.
Installing a Drive in the Rear Internal Bracket
Your computer has a hard disk drive installed in the rear
internal drive bracket.
Follow these steps to install a second drive in this drive bay:
1.
Remove the drive and power cables from the back of the
drive already installed in the rear internal drive bracket.
2.
Remove the four screws securing the rear internal drive
bracket to the computer’s back panel and slide it out of the
computer. Make sure you save the screws.
6-16
Installing and Removing Drives in the Tower Computer
Summary of Contents for ActionPC 8000
Page 5: ......
