3.
Remove the screws securing the drive on both sides.
4.
Reach behind the drive and gently push it out through the
front of the bay; then pull it out of the slot.
5.
Once you have removed the drive, replace the faceplate by
inserting one side of the plate, then gently pressing on the
other side until it snaps into place.
6.
If you removed the only IDE device connected to the
interface the device used, you may want to disconnect the
device cable from the main system board and remove it
from the computer.
7.
Replace the drive mounting bracket. See “Replacing the
Bracket in the Computer” for instructions.
8.
If you have finished installing or removing drives, replace
the computer’s cover, as described under “Replacing the
Cover” in Chapter 4. Then see “Using the Fixed Disk Setup
Option” in Chapter 2 for instructions on defining your new
drive configuration.
Installing and Removing Slimline Drives
5-23
