38
Using the Control Panel
2.
Press the
Pitch
button until the three Pitch lights indicate the desired
pitch. (The pitches available depend on which font you select.)
O
= On,
N
= Off
Changing the Printer’s Default Settings
While you can often change the printer’s settings through your software
or printer driver, you may sometimes need to change one or more of the
printer’s default settings. There are two ways to do this:
❏
Using the Epson Remote Configuration Manager on the printer
software CD-ROM. (See page 15.)
❏
Using the printer’s control panel default-setting mode.
For instructions on using the Remote Configuration Manager, see the
online
Remote Configuration Manager User’s Guide
on the CD-ROM. To use
the control panel, see below. For detailed information about default
settings, see the
Reference Guide
. The following table shows the options
available for each printer setting.
N N O
10 cpi
N O N
12 cpi
N O O
15 cpi
O N N
17 cpi
O N O
20 cpi
O O O
PS
Setting
Options (default in bold)
Page length for front
tractor
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11
, 70/6, 12,
14, 17
Page length for rear
tractor
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11
, 70/6, 12,
14, 17
Skip over perforation
Off
, On
Auto tear-off
Off
, On
Auto line feed
Off
, On
Print direction
Bi-D
, Uni-D
Summary of Contents for 2090 - LQ B/W Dot-matrix Printer
Page 6: ...6 Introduction ...
