Page 6
Maximum amplifier power 500W Impedance 4
Ù
Tweeter
Mid-Range
Bass
Designed and Engineered in Great Britain
www.epos-acoustics.com
Passive Operation
The Encore 50 is factory set
for passive use
For connections refer
to Owner’s Manual
To Bi-wire
remove Bass links (A)
To Tri-wire
Remove links (A & B)
Link A
Link B
Link A
Link B
Active Operation
Internal changes required
Refer to Owner’s Manual
or Epos website FAQs
Use only as instructed
Serial No
Insert the large hexagonal ALLEN key supplied and turn it in one or other direction to raise or lower the
spikes. Check the speaker is level with a spirit level. Adjust the spikes to avoid any wobbling. When the
position, height and level are approximately set, put the Tommy bar into the cross-hole in the small conical
locking device at the bottom and turn it anti-clockwise. Turn the Allen key in the top of the spike clockwise
at the same time and this will tighten the whole assembly and lock the spike in position. Do this to each
corner in turn. When you feel the position is right, fit the cosmetic discs to the top of the washers on each
corner of the plinth. Twist them by hand until finger tight. If you need to adjust the height or change the
angle of the loudspeakers again, remove all the cosmetic discs to reveal the hexagonal sockets at the top of
the spikes again.
CONNECTION
Ensure that your amplifier is switched off before you make, or break, any connections, because damage may
occur to your amplifier if shorted.
Your Epos loudspeakers are equipped with high quality insulated binding posts, with excellent electrical
contact and current specification. The posts are connected to the individual drivers as denoted on the rear
panel label.
The metal links between the terminals join the bass, midrange and treble drive units together enabling
conventional wiring, with a single high-quality speaker cable if required. Bi-wiring and bi-amping, tri-wiring
and tri-amping is possible. These techniques often bring benefits, in terms of increased clarity and
definition. Use only high grade speaker cables. For the best results, keep the cables no longer than
required.
CONVENTIONAL CONNECTION
(Single high quality speaker cable)
Summary of Contents for Encore 50
Page 1: ...Floor standing loudspeaker...
