Attach the brackets to the head and foot
boards (open end up) using the machine
screws provided.
Have a question?? Need a part ASAP?? Call 1 -800-589-7990 9 AM - 5 PM PST
Insert all four of the threaded steel dowels into
the foot board by hand. Slide the footboard slat
side in toward the side rails so that the dowels go
through the holes at the end of the side rails.
Slide the half moon
washer over the
dowel as shown.
Hand tighten the nut behind the half moon washer.
Repeat this process on the other side rail, then use
the wrench provided to tighten the nuts evenly.
1
Using four 110mm bolts and four barrel nuts,
attach the side rails to the headboard.
Note: Do one rail at a time and only hand tighten the bolts.
Once both sides
are threaded, fully
tighten the bolts
with the allen
wrench provided.
2
Attach the drop support to the center support by
inserting two 70mm bolts through the drop
support into the center support and tighten
with the allen wrench provided.
Lower the center support into the brackets.
3
Spread the slat bundle, strap side down,
evenly across the side rails.
Secure the first slat on one end then the final slat on the other
end, ensuring the slats are distributed evenly.
Use the remaining wood screws to secure all the slats
to the side rails with a Phillips head screwdriver.
A power screwdriver with clutch set to low comes in
handy for this step.
4
3
1
2
4
28-Sept-2018
2/2
