STEP 1
Using 4 x 110mm bolts and 4 x barrel
nuts attach the bed rails to the head-
board as shown in Figure 1. Note: Do
one rail at a time and only hand tighten
the bolts at this time.
Figure 1
Figure 2
STEP 2
Insert all 4 of the threaded steel
dowels into the footboard by hand.
Slide the footboard toward the side
rails so that the dowels go through the
holes at the end of the side rails. Slide the
bracket over the dowel as shown. Hand
tighten the nut behind the bracket. Use the
wrench provided to tighten the nut.
Note:
the narrow end of the nut should protrude
through the bracket when fully tighten.
6 x
STEP 3
Using the 12 machine screws provided, attach
the 2 steel center support brackets (open end
up) to the foot and head board as shown in
Figure 3.
Figure 3
