Resetting the
epoc
Host
The
Soft Reset
button is recessed in the bottom
of the epoc Host. To perform a Soft Reset, insert
the stylus into the opening on the bottom of the
Host Cradle. The Soft Reset Button may be used
to restart the Host application if the epoc Host
stops functioning and/or responding.
If the Soft Reset Button does not respond,
then at the same time, press the top two
(2) Buttons and the Soft Reset Button
(as shown) to perform a
Hard Reset
.
NOTE: Never perform a reset during a test. This ends the test immediately.
NOTE: Always verify that date and time are correct after performing a Hard Reset.
Removing the Cradle (to access SD Slot and / or replace Battery)
To remove the
Version A
cradle (
with black rubber back
):
1. Turn off epoc Host.
2. Fold back corners of Rubber Cover to
expose two (2) attachment Screws.
3. Remove two (2) Screws using correct
Screwdriver.
4. Slide Scanner Bracket forward and up to
release Barcode Scanner. Pull Barcode
Scanner from Slot.
5. Lift Host up and out to remove from Cradle.
6. SD slot is beneath the Barcode Scanner.
If needed, carefully pull Barcode Scanner
from its slot to gain access.
7. Use the Stylus to release Battery Cover.
8. Remove Battery Cover from back of Host.
9. Remove Battery.
10. Replacement Battery information is found
in Section 13 of the
epoc
System Manual.
11. Replace Battery Cover and fasten securely.
12. Re-assemble Host into Cradle. Carefully
align Host with Cradle Connector. Insert
Barcode Scanner through Rubber Collar.
Slide Scanner Bracket tightly in place.
Fasten two (2) attachment Screws.
