EpiValley SDT1100, User Manual

Page: 42 / 42

C
aution
The R2NSDT1100 has been tested for compliance FCC RF exposure limits. The R2NSDT1100 should not be used with external
antennas that are not approved for use with this device.
Use of this in any other configuration may exceed the FCC RF exposure compliance limits.
A separation between the user’s body an
d the antenna shall be at least 20cm.
WARNING! Read this information before use
C
aution
Modifications not expressly approved by the party responsible for compliance could void the user
’
s authority to operate the
equipment.
FCC Compliance Information
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any interference received. Including interference that may cause
undesired operation.
Information to User
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ tv technician for help.