pg.6
© 2013 Episode
®
ES-LS-SAT Installation Manual
5.6 Connecting the Amplifier and Testing
1. After wiring each loudspeaker into the run and setting the taps, attach the speaker wires to the amplifier,
making sure to mirror the wiring pattern used in the loudspeakers, + to + and – to -. Connect the amplifier to
a source and to power and test the system.
2. Listen to the system from several locations in the audible area. If an area is too loud or quiet, adjust speaker
taps or the amplifier volume accordingly until the volume and sound quality is optimized.
3. After optimizing the settings, check the total wattage again to be sure the amp isn’t being overworked. It is a
good idea to let the system play for about a half hour after setup is done to be sure that the system is reliable.
4. Once the system has been set and tested, the wiring or conduit can be buried or hidden. For any issues with
operation or sound quality, please see the Troubleshooting section before contacting Episode for additional
support.
6. SPECIFICATIONS
ES-LS-SAT-4
ES-LS-SAT-6
Woofer
4" Polypropylene
6" Polypropylene
Tweeter
¾” Aluminum Dome
¾” Aluminum Dome
Power Handling
90w RMS
120w RMS
Tap Settings
70V
100V 8Ω
70V
100V
8Ω
3.75w
7.5w
Transformer
Bypass
3.75w
7.5w
Transformer
Bypass
7.5w
15w
7.5w
15w
15w
30w
15w
30w
30w
30W
Frequency Response (-6db)
116 Hz – 19 kHz
105 Hz – 19 kHz
Sensitivity (-2.83 V / 1 Meter)
83.5
86.5
Crossover Frequency
2.9 kHz
2.9 kHz
Weight
4.25 lbs
6.7 lbs
Grille Type
Perforated ABS
Perforated ABS
7. TROUBLESHOOTING
Episode
®
loudspeakers are designed to function trouble-free. Most problems that occur are due to simple issues. If
you have trouble, please check the list of simple fixes below. If the problem persists, contact Episode® Customer
Service at 1.866.838.5052
No Sound
• Verify that there is audio coming from the source selected. Select another source if necessary.
• Ensure that the audio source is turned on and connected properly.
