Episode ECS-500-AW70V-4, Installation Manual, Page: 6 / 12

page | 6
Support 866.838.5052
DETACH SPEAKER FROM BRACKET
To remove the speaker from the bracket,
loosen both retention knobs on the sides
of the speaker. Pull the bracket away
from the top and bottom of the speaker
and then slide the speaker from the
bracket.
Loosen
retention
Knob
Pull Bracket
away from
Speaker
ADJUSTMENTS
Refer to the manual for the receiver or amplifier to make sound adjustments such
as bass, treble and balance to obtain the preferred sound.
ECS-500-AW70V Speaker Tap Settings
The 70V speakers have an adjustable tap setting switch located under the
removable rear cover. To adjust, rotate the tap setting dial on the rear of the
speaker to the desired setting.
The 70V speakers used in 70/100 volt systems can be set to different wattages for
more or less volume at one particular speaker. Making it much easier to fine tune
a system for even listening volume.
!
CAUTION:
The speaker tap must be set accordingly for the load capacity of
the amplifier in use. Setting the transformer incorrectly for the amplifier
used could damage the speakers or amplifier.
When the adjustments are complete and fully tested, install the rear cover of the
speaker and press into place until secure.