EPILOG LASER
16371 Table Mountain Parkway
Golden, Colorado 80403
Phone 303-215-9171 - FAX 303-277-9669
www.epiloglaser.com
REPLACING THE LASER TUBE IN THE
EPILOG MINI ENGRAVER
Tools needed: Phillips head screwdriver #1
1. Turn engraver off and unplug
2. Facing the back of the machine, remove the 9 screws using the Phillips head screwdriver on the
back panel. (PIC 1)
3. The laser tube is silver in color and sits directly above the exhaust outlet. Disconnect the gray
communication cable from the left side of the laser tube by pressing the plastic tab on it and pulling
it free from the laser tube itself. (PIC 2)
4. Next, disconnect the black and red wire connection located on the left side of the laser tube by
unplugging it from the wiring harness. To do this, simply press down on the plastic tab of the
connector and pull free from the plug of the wiring harness. (PIC 3)
1 2 3
5. You will now need to unplug the Red Dot pointer. This is located on the right side of the laser
tube. There is a small red and black wire that comes from the diode and connects to a black
connector. Disconnect this connector by pressing on the plastic tab and pulling the connector free.
(PIC 4).
Summary of Contents for MINI
Page 3: ......
