Operating Instructions
Page 2 of 2
RFC - RF Cylinder Thermostat
10. To disconnect the RF thermostat with the programmer
9. To connect the RF thermostat with the programmer
Lower the cover on the front of the timeswitch /
programmer. Move the selector switch to the
RUN position.
Lower the cover on the front of the timeswitch /
programmer. Move the selector switch to the
RUN position.
On the timeswtich/ programmer, press the button for 5 seconds.
This will take you into the Wireless Connect screen.
Press the button for 3 seconds.
This will clear all RF connections thereby disconnecting all thermostats from
the timeswitch / programmer.
Press the button.
On the timeswitch / programmer, press the button for 5 seconds.
Wireless Connect will appear on the screen.
On the RFR wireless room thermostat or RFC wireless cylinder
thermostat, press the
Code button. This is located inside the housing
on the Printed Circuit Board.
On the timeswitch / programmer, the available zones will begin to flash.
Press the button for the zone you wish to connect the
thermostat to.
The wireless symbol appears on the screen.
The thermostat will count upwards to the number of the zone that it is
paired with. When it reaches the number of the zone that it is paired
with press the hand wheel on the thermostat.
The timeswitch / programmer is now operating in the wireless mode.
The temperature of the wireless thermostat is now displayed on the
programmer. Repeat this process for the second, third and fourth zone
if required.
RUN
CLOCK
SET
PROG
SET
RUN
CLOCK
SET
PROG
SET
EPH Controls Ireland
Sitecast Industrial Estate, Pouladuff,
Cork, T12 W665, Ireland
[email protected] www.ephcontrols.com
EPH Controls UK
Unit E4, Welland Business Park, Valley Way, Market Harborough,
Leicestershire, LE16 7PS, United Kingdom
[email protected] www.ephcontrols.co.uk
20170302_A
W1077_RFC-RF_OpI
ns_JW
