Epever IP1500-12-Plus(T), User Manual

Page: 18 / 36

15
6. Installation instructions
6.1General installation notes

Please read the manual carefully to get familiar with the installation
steps before installation.

Be very careful when installing the batteries, especially flooded
lead-acid batteries. Please wear eye protection, and have fresh water
available to rinse if any contact with battery acid.

Keep the battery away from any metal objects, which may cause a short
circuit of the battery.

Loose connections and corroded wires may result in high heat that can
melt wire insulation, burn surrounding materials, or even cause a fire.
Ensure tight connections and use cable clamps to secure cables and
prevent them from swaying in motion.

Please follow the parameter list to connect the DC input, even though
the inverter has a high range of DC input voltages. Too high or too low
may cause the inverter to stop working, even damage the inverter
(Surge voltage less than 20V for 12V system, 40V for 24V system,
80V for 48V system)

Select the system connection cables according to the current density no
higher than 3.5A/mm
2
.(In accordance with the National Electrical Code
Article 690, NFPA70).

For outdoor installation, keep out of the direct sunshine and rain
infiltration.

High voltage still exists inside the inverter after turning off the switch, do
not open or touch the internal devices, wait ten minutes before
conducting related operations.

Please do not install the inverter in humid, greasy, flammable, explosive,
dust accumulative, or other severe environments.

AC output is a high voltage, and please do not touch the wiring
connection.

When the fan is working, and please do not touch it to avoid injury.