REV. 07/2020
2
D
Using the truck for the first time
The truck must only be operated on battery current!
To prepare the truck for operation after delivery or transportation, the following operations must
be performed:
Check the equipment for completeness.
If necessary, install the battery. Make sure that the battery cable is not damaged.
Charge the battery.
Put the truck into operation in the stipulated manner.
When the truck is parked, the surface of the tyres may flatten. The flattening will disappear
after the truck has been operated for a short time.
Check for fluid leakage.
Check forks and chassis.
Check battery connector.
Check decal condition.
Check control handle pivot.
Check operating controls.
Break-in period precautions
Fasten wheel screws again at 50 hours of operation.
Within the first 100 hours in particular, the following requirements should also be met:
Excessive discharge of a new battery during initial use must be prevented.It should
generally be charged promptly when at 20%.
The specified preventive maintenance must be done thoroughly.
Avoid sudden braking, driving quickly or sharp turns.
Change oil or lubricant promptly according to the instructions.
Limit the load weight to 70-80% of the rated load.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
1.3
1.4
Prevent the truck from rolling away.
Remove the cover(see section 1.4.2 Remove the
cover -G).
Screw in two screws(2), M4 *35mm)until the truck
can be moved (no braking action).
After setting down the truck at the destination, unscrew two screws(2).
Braking action is restored!
•
•
•
•
•
