05
06
If the truck has to be transported for a long distance, it should be packed in the wooden pallet in order
to avoid collision during transportation..
1
.
Hydraulic oil
Please check the oil level every six months and change the oil every twelve months. 2. 32 #
hydraulic oil is recommended, with total volume of about 0.5 liters.
2
.
Remove the air
The air may enter into the pump because of transportation or pump in upset position. It will cause
the forks fails to be lifted when the finger grip control handle switched to the lifting position. The
air can be removed in the following way: pull the finger grip control handle (1-1) to the lowering
position and move handle up and down for several times.
3
.
Daily check and maintenance
Daily check and maintenance of the pallet truck can limit wear as much as possible. Special
attention should be paid to the wheels, the axles, as thread, rags, etc. may block the wheels and
axles. The forks should be unloaded and lowered in the lowest position when the job is over.
4
.
Lubrication
All bearings and pivots are provided with long-life lubricants at the factory. You only need fill the
lubrication points with long-life lubricants at monthly intervals or after each time the truck is
cleaned thoroughly.
Maintenance
1 The truck should be parked with the forks lowered to the min. height.
2 Check if the signs and warning labels on the truck are in place before using the truck each time.
3
Use original parts.
4 The waste liquid shall be place in special collection places for disposal.
5 Modifications or alterations to the truck, especially the safety device are prohibited.
6 Only customer service persons specially trained by our company can carry out maintenance
of the truck.
7 Thoroughly standardized maintenance is the most important preconditions to ensure stable
and reliable operation performance of the truck. Neglect of regular maintenance could result
in failure and malfunction of the truck and poses a potential threat to the safety of the staff and
operation.
M25 / 30 Series Manual Pallet Trucks
Transport, loading, test run and storage
The handle should be fixed stably in case sliding and damages and transported by fork truck
or crane.
Before shipment, the operator should first check the truck weight, in order to choose the right
crane.
When unloading the truck, the operator should be aware of safety of the surroundings to ensure
the truck slowly unloaded.
If the truck is transported with the forklift truck, the forklift shall lift and lower it slowly to keep
the balance of the truck.
The truck shall be commissioned according to the following function tests: steering, traveling,
braking and combined functions with rated capacity.
When a truck is inoperative, the cargoes (if applicable) shall be removed with proper tools, the
truck shall be transported out of the working zone with a proper way.
When the truck will be shut down and in storage for a long time, the storage environment shall
be kept dry and clean, with forks lowered to their lowest position.
