Adjusting finger grip control handle
05
06
On the handle of this stacker, you can find finger grip control handle (3-1) which can be
regulated in three positions :
However if they have been changed, you can adjust them according to the following steps:
①
If the forks elevate while pumping in the Middle position, turn the adjusting nut (4-2) on the
adjusting bolt (4-1) or screw (4-3) clockwise until pumping action does not raise or lower the forks
and the finger grip control handle (3-1) works properly Middle position.
②
If the forks descend while pumping in the Middle position, turn the adjusting nut (4-2) on the
adjusting bolt (4-1) or screw (4-3) counterclockwise until pumping action does not raise or lower
the forks and the finger grip control handle(3-1) works properly Middle position .
③
If the forks do not descend when the finger grip control handle (3-1) is in the Lowering position,
turn adjusting nut (4-2) on the adjusting bolt (4-1) or screw (4-3) clockwise until raising the control
handle lowers the forks. Then check the Middle position according to items
①
and
②
to make sure
the nut (4-2) and screw(4-3) are in the proper position.
④
If the forks do not elevate when the finger grip control handle (3-1) is in the Lifting position, turn
adjusting nut (4-2) on the adjusting bolt (4-1) or screw (4-3) counterclockwise until turning the
control handle to that position lifts the forks. Then check the function of the Lowering position and
Middle position according to items
①
,
②
and
③
is normal.
Transport, loading, test run and storage
Figure
3
Figure
5
Before loading, the operator shall check the stacker weight to choose the suitable
hoisting equipment. When the stacker is unloaded, the operator shall look out for
safety around to ensure safe landing of the stacker.
The truck shall be commissioned according to the following function tests: steering,
traveling, braking and combined functions with rated capacity.
When a stacker is inoperative, the loads (if applicable) shall be removed with proper
tools, the stacker shall be transported out of the working zone with a proper way.
Shut down and in storage for a long time, the storage environment shall be kept dry
and clean, with forks lowered to their lowest position.
As shown in Figure 5, lifting points are on both sides of the stacker.
Figure
4
3
-
1
Lowering
Middle position
Lifting
4
-
1
4
-
2
4
-
3
Lift - lifting
Middle position - travel
Lower - lowering
1
2
3
H10
/
15
/
20
Series Manual Pallet Stackers
