8
9
Zero the scale
10.1. Operation
HMI
10.Operation
10.2. Basic function operation
10.2.1 Zero
10.2.2
Tare/Clear
Tare the scale at the Gross Mode and switch to the Net mode
Clear `the tare at the Net Mode and switch to the Gross mode
By pressing the key, the scale changes the unit between kg and lb. Capacity and resolution will
be calculated
By pressing the key, the stable weight data is output from serial port while the terminal is
power-on.
Hold the key 2s, the terminal switch off while the terminal is power-on.
Hold the key 2s, the terminal switch on while the terminal is power-off.
10.2.3
Unit Switch
10.2.4
Print/On/Off
Note:
1.
Only the IND212-501Y type has the serial port.
2.
After initialization while the terminal powers on, it shows [CHARG], by pressing
, the terminal
enters charging mode. If
,
o r
is pressed, or nothing to do within 10s,
the terminal enters normal weighing mode.
11.1.
Entering a number
KEY
Function Description
Print-Key, Enter-Key: YES
T
Tare-Key: NO
F
F-Key: While entering a number -> move one digit to the left
0
Zero-Key: One step back
10.3.
Over capacity and Under Zero
10.3.1. Over capacity
If the weight in scale is more than Full capacity
+9d, then the indicator will display:
10.3.2. Under Zero
If the weight in scale is less than -5 d, the
indicator will display:
11.Setup
To entering a number (e.g. calibration weight) the following sequence is used:
1） Display shows a blinking 0. With the Tare-Key the number can be increased. With the Zero-Key the
number can be decreased. Once the correct number is displayed, the F-Key moves the cursor to the next
digit to the left.。
2） Continue with 1). If the correct number is displayed pressing the Print-Key confirms the complete
number.
3） By pressing the Clear-Key during the input of numbers, the cursor will jump one step to the right (that
number will start to blink) and the selected digit can be changed with the Tare-Key.
11.2.
Entering Setup
Press and hold
to
enter
s
etup
. T
he
t
erminal
w
ill
e
nter
M
aster
M
ode
.
After about 2 minutes the terminal will time out and go back to the weighing mode.
After entering the password confirm with enter-key, the terminal will enter Setup:
Password of Supervisor:
Supervisor mode: Setup F1 function block only.
Administrator mode: Setup all function block.
Password of Administrator:
