EOS Gracil Series, Assembly And Operating Instructions Manual

Page: 21 / 26

21 D
Assembly instructions
Fig. 1
Mounting example Gracil
The sauna heater, when made use of time pre-
set and remote control*, may only be used with
an appropriate cover protection or any other
safety device.
*Remote control – means settings, switching, control
and adjustment of the sauna control unit by means of
commands transmitted from a remote location beyond
sight distance using telecommunication, wire- or wire-
less signal transmission systems, network and similar
systems.
Fig. 2
min. 190 cm
70 cm
76 cm
max. 11,5 cm
50,5 cm
Cabin celling
Fig. 3
Fixation to the wall
back
The stove guard is not included in the delivery
and has to bell well installed by the cabin fa-
bricant.
Contents
The contents are as follows:
• 1 Sauna heater
• 1 polybag with
2 mounting brackets
4 hipboard screws 5x35
1 cable gland
• 1 sauna stone units packed separately
packed in a woven sack
Minimum distances
• The minimum height of the sauna cubicle is
1.90 m on the inside (Fig. 1)
• When you are assembling the sauna heater
you must ensure that the vertical distance
between the top edge of the sauna heater
and the sauna ceiling is at least 90 cm and
that the horizontal (at the side) distance bet-
ween the heater and cabin wall is at least 6
cm (Fig. 2).
• The distance from the heater grid and the
bench to other inflammable materials near
the heater must be at least 4 cm. The heater
grid must be more or less the same height as
the front of the heater.
stove guard
sauna cabin wall
air inlet
absolutely necessary,
centred to collection tray
50,5 cm 6 cm 6 cm
25,5 cm
6 cm
6 cm