ca. 35 cm
Installation of the control unit
Wall installation
The control unit may only be mounted outside
the sauna cabin. It is advisable to select the out-
side wall of the cabin to which the sauna heater
is fi xed from the inside as mounting position. If
ductwork is already provided for electrical in-
stallations then the position of the control unit
is predetermined by that. Please follow the in-
structions for installation:
Fig. 1
1. The 3 mm diameter boreholes for the sup-
plied wood screws 4 x 20 mm are drilled
according to the dimensions shown in Fig. 3
+ 3.1.
2. Insert one of the wood screws into the top
center hole. The control unit is hooked onto
this screw. Therefore, leave the screw out by
approx. 3 mm (Fig. 3.2).
3. Hook the control unit onto the 3 mm protru-
ding screw in the upper mounting hole.
Insert the supplied rubber grommets into
the openings at the rear wall of the housing
and insert the connecting cable through the-
se openings.
Fasten the housing bottom at the two bot-
tom openings (Fig. 4) fi rmly to the cabin wall.
Fig. 3
E
ye lev
el
Fig. 3.2
3 mm
Upper mounting hole
Mounting holes
Fig. 3.1
approx. 35 cm
17 cm
17.7 cm
E
ye lev
el
Remove the control device cover. In order to do
this loosen the screw at the top of the housing
and pull the housing top upward while swivel-
ling (Fig. 1).
Surface-mounted installation
Fig. 4
Feed-through for:
Mains cable
Heater cable
Evaporator cable
Lamp
Fan
Feed-
through for
sensor lines
8
GB
