3
GB
1
.3 General safety precautions
l
This device has not been designed for
being used by persons (including
children) that are physically or mentally
handicapped or have sensory
disabilities. Moreover, it is not allowed to
use this device without sufficient
experience and/or knowledge, unless
these persons will be supervised by
persons responsible for their security or
in case they have been instructed how to
use this device.
l
Children are to be supervised in order
to make sure that they do not play with
this device.
l
Attention:
It is forbidden to install the
control box in a closed switch cabinet or
behind a wooden panelling!
l
The electrical installation may be done
only by a qualified electrical technician.
l
You must comply with the regulations of
your electrical supplier and applicable
VDE regulations (DIN VDE 0100).
l
WARNING: Never attempt repairs
or installations yourself, as this
could result in serious injury. Only a
qualified technician may remove the
housing cover.
l
Please note the dimensions in the
assembly instructions, especially when
installing the temperature sensor. The
temperature above the oven is critical for
the temperature setting. The temperature
can be held within operating parameters
and a minimal temperature gradient
inside the sauna cabin can be achieved
only if unit is assembled correctly.
l
The device may only be used as intended
as a control unit for sauna ovens up to 9
kW. (Up to 36 kW when combined with a
breaking capacitor).
l
Completely disconnect the control unit
from the electrical circuit, i.e. flip all circuit
breakers or the main circuit breaker
during installation or repair.
l
Please note the safety and installation
information from the sauna oven
manufacturer.
2 Assembly of the control unit
2.1 Wall mounting
Mount the control unit outside the sauna
cabin only. The most practical mounting
point would be the wall area onto which
the sauna oven is mounted on the inside,
except on the outside of the cabin. If
electrical conduits are present, mount the
control unit accordingly. To mount the
control unit, please follow these
instructions:
Illust. 1
Fastening screws
1. Remove the cover of the control unit.
Loosen the fastening screws below the
control panel. If your unit uses control
knobs, remove them. Enlarge the holes
for the electrical cables (Illust. 4) with a
sharp knife. Drill the threaded holes for
the included 4 x 20 mm wood screws
according to Illust.s 3 & 3.1.
2. Insert one of the wood screws into the
upper middle hole. This screw will be
the mounting point for the control unit.
Make sure the screw is projecting out
about 3 mm. (Illust. 3.2)
3. Hang the control unit onto the 3 mm
projecting screw. Lead the electrical
cable through the holes you enlarged in
step 1 and screw the lower part of the
housing onto the cabin wall using the
lower threaded holes. (Illust. 4)
