EOS Zeus S / EOS Zeus SL - Installation and Operating Instructions
EN-35
Connections
4.2.4
Establishing an electrical connection
The connections for the heating coils are attached to the bottom of the
heater. The lines are pre-mounted and must be connected to the power
supply.
The silicone connection cable is firmly connected inside the terminal box.
Two separate cables for output capacities 10.5 kW and 12 kW are con-
nected. The connection cables are 8 m long.
Connecting the connection cable to the sauna relay box
1
Route the connection cable along the internal side of the heater wall
downward.
2
Route the connection cable outward.
The following alternatives are available depending on how the cable
duct is prepared:
a)
Guide the cable through the air inlets.
b)
Pull the cable through the openings in the drip pan and under the
heater.
Lay the connection cable looped in a suitable place to facilitate
disassembly of the heating element.
3
Guide the cable from the cabin to the sauna relay box.
4
CAUTION! Ensure that the relay box has no power.
Connect the cable, see:
a)
4.2.1 Terminal diagram 6 kW/7.5 kW/9 kW,
b)
4.2.2 Terminal diagram 10.5 kW/12 kW,
c)
