INSTALLATION GUIDE
3) Assembly Overview
1.
Lay the end panel of the table
down to gain access to the pockets
at the bottom of the panel. (Figure
1)
2.
Nest bracket in the pocket on the
bottom of end panel. (Figure 2)
3.
Install 2 (.25 x 2” Hex Head lag)
through the two holes of bracket into the pre-dilled holes of the
end panel. Next to the weld nut.
(Figure 3 Circled)
4.
Install 4 (screw 1) into the side of
the end panel through the four
holes of the bracket. (Figure 3 See
arrow)
5.
Install caster into nut on bracket
and tighten with wrench. (Not
Shown)
Note:
1.
Steps 2 & 3 are repeated for
second bracket. Two brackets and
four lags are used in the assembly
2.
Repeat this assembly for each end
Figure 3
panel.
Figure 1
Figure 2
