Version: Nov 16
Call 1300 369 273
www.enware.com.au
Enware Australia Pty Limited
9 Endeavour Rd Caringbah NSW 2229 Australia
Ph: 02 8536 4000 Fax: 02 8556 4055
Barrier Free Hi-Lo Wall Mounted
Drinking Fountain with Chiller
NOTES
1. HOLD ROUGH-IN DIMENSIONS ±1/8” (3.2MM)
2. WHEN INSTALLING THIS UNIT. LOCAL STATE OR NATIONAL
CODES SHOULD BE ADHERED TO. FOR DIMENSIONS
(LOCATIONS), WASTE AND SUPPLY REQUIREMENTS OTHER
THAN SHOWN, DIMENSIONS MARKED * MUST BE ADHERED
TO ACCORDINGLY.
3. INSTALLER MUST PROVIDE TRAP FOR PROPER INSTALLATION
REFER TO 5874/VRK5874 OPERATION AND MAINTENANCE
MANUAL FOR PUSH BUTTON AND VALVE INSTALLATION/
MAINTENANCE INSTRUCTIONS.
INSERT 5/16”-18 PANEL INSERTS FROM OPPOSITE SIDE AT
LOCATIONS SHOWN BY DARKENED HOLES. COMBINATIONS
SHOWN ARE FOR USE WITH LOW FOUNTAIN ON THE RIGHT
AND THE HIGH FOUNTAIN ON THE LEFT. USE OPPOSITE HOLES
FOR HIGH ON RIGHTS AND LOW ON LEFT
COMBINATIONS SHOWN ARE FOR USE WITH LOW FOUNTAIN
ON THE RIGHT AND HIGH FOUNTAIN ON THE LEFT. USE
OPPOSITE HOLES FOR HIGH ON RIGHTS AND LOW ON LEFT
TO CHANGE FOUNTAIN MTG. SCREW LOCATIONS: FIRST
REMOVE SCREWS AND THEN SQUEEZE CLIPS ON NUT
RETAINER TO POP OUT. SNAP INTO NEW POSITIONS
AND REASSEMBLE SCREWS.
ALIGN HOLES IN CHILLER SUPPORT TRAY WITH HOLES IN
FRAME AND FASTEN WITH #10 SHEET METAL SCREWS
IMPORTANT: A L.H LOW (OPTIONAL) CONFIGURATION WILL
REQUIRE A DIFFERENT BACK PANEL AND THE WASTE AND
SUPPLY DIMENSIONS SHOWN (*) WILL BE REVERSED.
