Safety First
Even though EP units are designed for common installation, electricity is dangerous
and only qualified personnel should attempt installation.
1.
Read and understand entire contents of installation manual prior to installation.
2.
Measure voltage of the electrical panel where the installation is taking place.
3.
Verify that voltage and electrical configuration matches the model of the EP unit being installed.
4.
If the model number does not match DO NOT install.
S.
Turn off electrical supply prior to any installation in electrical panel.
6.
Verify with voltage meter that electricity is off.
7.
Ensure all connections in electrical panel are secure and all tools and equipment have been removed
from electrical panel before re-energizing system.
WARNING
,&
ALWAYS
have a professional electrician with proper safety equipment perform installation.
Do NOT install waveform corrector on the output of a variable frequency drive
Pre-Installation Preparations
1.
Read entire contents before performing installation.
2.
Verify the voltage rating of the system before installing the EP unit. Make sure the electrical system
operates at or below the maximum continuous operating voltage of EP product.
It should not exceed five (5) percent of the rated nominal voltage of the unit.
Note: If you hove questions regarding voltage ratings, contact EP.
3.
Check all the fuses of the electrical system before installing
EP
unit.
4.
Make sure the power distribution configuration of the EP unit matches with the configuration
of your electrical system (Delta or WYE).
5.
Make sure your EP product is suitable for your application.
Note: Call EP ta confirm the product application.
3
EP-
HPF
Series INSTALLATION GUIDE
