8
2. Turn the gas control knob to pilot, push in and hold (see Figure 4);
Simultaneously, press the piezo ignitor several times until the pilot
ignites. Hold the gas control knob in for at least 30 seconds once lit.
Check that the pilot has fully engulfed the thermocouple assembly (see
Figure 3). The pilot should now stay lit on its own, release gas control
knob.
Note: This stove must be wired with an external burner switch
or thermostat for safety and convenience.
Thermopile
Thermocouple
Figure 3. Pilot Flame
Operating Instructions
For Your Safety, Read Safety Precautions And
Lighting Instructions Before Operating
TO TURN GAS FIREPLACE OFF:
Flip switch to OFF to turn off burners, turn the gas control knob to OFF to extinguish the pilot flame. Keep
the pilot flame
OFF
when not in use for long periods. If the fireplace is to be serviced, turn the gas shut
off valve OFF (DO NOT FORCE IT) and disconnect all electrical power sources. See Figure 4 for control
panel layout.
NOTE:
When the unit is turned on for the first time, it should be turned onto high, with the fan OFF
for the first two to four hours.
This will cure the paint, logs, gasket material, and other products used
in the manufacturing process. It is advised that a door or window be opened as the unit will start to
smoke, which can irritate some people. After the unit has gone through the first burn, turn the unit OFF,
including the pilot, and let the unit get completely cold. Then remove the glass and clean it with a good
gas fireplace glass cleaner, available at your local Enviro dealer (See
M
aIntenance
a
nD
s
erVIce
- G
lass
D
oor
r
eMoVal
and
M
aIntenance
a
nD
s
erVIce
- c
leanInG
t
he
G
lass
).
b
uRneR
L
iGhtinG
:
1.
Make sure pilot is lit, if not light it (see above).
2. Turn gas control knob counter-clockwise to ON; if already ON, see next.
3.
Flip burner switch to ON.
4. Turn HI/LO control knob to the desired flame height.
5. Check that all burner holes are lit.
P
iLot
L
iGht
:
1. Turn off the gas to the fireplace. I
f not recently done, remove the glass and let the unit air out
for at least five (5) minutes to clear out any gas.
Turn on gas to the heater.
A
DETAIL
A
SCALE
1 : 5
Fan Control
Piezo Ignitor
Burner Switch
Air Shutter Control
ON/OFF/PILOT
HI/LOW
Figure 4. Burner Controls
Summary of Contents for G39L
Page 51: ...51 Parts Diagram 1 2 3 5 13 6 7 14 8 9 10 11 12 4...
Page 52: ...52 Notes...
