Secondary Installation
o
ptionaL
3
anD
4 s
iDeD
t
RimmabLe
p
aneLs
:
Modifying the Surround Panel:
The E30 Trimmable Surround Panels are large rectangular panels that may be cut for use in cases that a non-
standard fireplace opening (e.g. an arched opening) is to be filled. Optionally this surround can be left uncut
and placed in front of the fireplace opening.
1. Measure the fireplace opening and/or make a template of the fireplace opening.
2. Transfer the measurement to the Trimmable Surround.
3. If desired, offset the measurements by approximately
1
/
8
” (3mm) to the inside; this will allow for the panel
to be placed just inside the fireplace opening for a cleaner appearance.
4. Cut along the preferred line (from direct measurements of offset) and remove any sharp edges.
5. The panel can be touched up with a high temperature metallic black paint available from your dealer.
REGULAR DEPTH INSTALLATION:
1. Install the two Trimmable Panel brackets onto the E30 unit using a T-20 Torx screwdriver.
See Figures 46
and 47
for the screw installation locations. There are three sets of hole patterns on the brackets depending on
which Surround Panel is being installed. See Figures 47-51.
34
Figure 47: Screw
Installation Locations.
Figure 49: Installation for Contemporary
and Extruded Surround.
Figure 48: Screw
Installation Locations.
Figure 50: Installation
for Regular Surround.
DATE: 13/01/2012
BY
SHERWOOD INDUSTRIES LTD.
INTERNAL ASSEMBLY MANUAL
STATION:
THIS DRAWING IS THE PROPERTY OF SHERWOOD INDUSTRIES LTD. AND MAY NOT BE COPIED, REPRODUCED, OR OTHERWISE DISCLOSED WITHOUT THE PRIOR APPROVAL OF SHERWOOD INDUSTRIES LTD.
STEP:
1 of 1
SHEET:
E30 Master
PART NUMBER:
UPDATED: ----/--/--
BY --
STATION 1
STATION 3
STATION 4
STATION 2
Figure 51: Screw
Installation Locations.
Installed Brackets
NOTE: The Extruded and Contemporary Surround Panels use the same holes for mounting the Side Cabinet
Extensions. The Regular Surround Panel uses its own set of holes.
