6. INSTALLATION OF LOG SET and EMBERS
INSTALLING THE GLOWING EMBERS
A bag of ceramic fiber embers is provided for use on the front burner ember tray.
CAUTION: Use only the type of ember material supplied with this appliance. Due to the irregular size of the
ember material there may be more than required. Use only a single layer. Do not pile embers. The use of
other foreign materials on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement, contact your nearest
ENVIROGAS dealer for replacement embers.
Gently remove the ember material from the plastic bag.
Spreading pieces evenly across the front and rear of the ember
tray, place a single layer of embers on top of the front burner.
Carefully avoid any clumping or large build-ups. Do not pack
down, leave embers loose.
Place cast ember pieces between the door facing and the
ember tray. The curved edge is placed into the firebox. Align
the mitered corner edges.
DO NOT PLACE EMBERS ON THE REAR BURNER.
CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE DOOR REMOVED
INSTALLING THE LOGSET
Carefully remove log from box. Check to ensure there is no damage. It is very important to install this log
in its proper position to insure safe, optimum
operating conditions.
1.
Open the front door.
2.
Place the logset all the way into the back of the
firebox resting on the log supports.
3.
Close the door and tighten securely.
Upon the first light up, watch for ignition to
all
burner
ports. If a long delay is noted:
a)
First, wait for the appliance to cool down
b)
Open the front door of the appliance.
c) Check to carefully reposition the embers making
sure that burner ports are not plugged solid or
blocked.
(See adjusting the venturi section to adjust air for
proper flame).
10
